Answers are grounded in this paper and cite their sources.
Wire electric discharge machining (WEDM) is one of the foremost methods which has been utilized for machining hard-to-cut materials like Titanium alloys. However, there is a need to optimize their important operating parameters to achieve maximum material removal rate (MRR). The present paper investigates the effect of control factors like current, pulse on time ( T on ), pulse off time ( T off ) on MRR of machining of Ti-6Al-4V alloy. The study showed that, increase in current from 2 A to 6 A results in a significant increase in MRR by 93.27% and increase in T on from 20 μs to 35 μs improved the MRR by 7.98%, beyond which there was no improvement of MRR. The increase in T off showed a counterproductive effect. Increase in T off from 10 μs to 30 μs showed an almost linear decrease in MRR by 52.77%. Morphological study of the machined surface showed that cut surface consists of recast layer on which microcracks were present, and revealed the presence of globules, ridge-structured formations of recast layers and voids. In addition, a regression model was developed to predict the MRR with respect to the control factors, which showed a good prediction with an R 2 value of 99.67%.
No takes yet. Share an insight, caveat, or question.
Deepak et al. (2022) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: