Key points are not available for this paper at this time.
Design
Review
Answers are grounded in this paper and cite their sources.
May aid echo assessment of LV diastolic function; leaves open prospective validation of parameters before routine adoption.
Introduction The clinical importance of the diastolic function of the heart cannot now be questioned [1]. It is increasingly recognized that impairment of left ventricular diastolic function produces significant haemodynamic abnormalities, which may contribute substantially to, or be fully responsible for, the pathophysiology of many cardiac diseases [2-4]. In conditions such as left ventricular hypertrophy induced by pressure load (hypertensive heart disease or aortic stenosis) and hypertrophic or restrictive cardiomyopathy, diastolic dysfunction may lead to frank cardiac failure even when systolic function is normal [5]. During acute myocardial ischaemia, diastolic dysfunction occurs simultaneously with regional systolic wall motion abnormalities and before global systolic dysfunction or electrocardiographic changes of ischaemia. It may contribute significantly to the development of haemodynamic compromise and cardiac failure. The precise meaning of diastolic function and how to evaluate it raise complex questions. Unlike systolic function (which represents the properties and effects of myocardial contraction alone) [6,7], diastolic performance is described in terms of two distinct and occasionally discordant concepts - relaxation and compliance [8,9]. Definition and description of diastolic function Diastole, from the Greek word διαστολη, meaning 'a drawing asunder or expansion', was defined by Wiggers in physiological terms as what happens between the opening of the atrioventricular valve (and onset of ventricular filling) and the closure of the mitral and triscuspid valves (at the start of ventricular contraction). Good diastolic function may be defined in terms of the ability of the ventricle to accommodate an adequate filling volume at a low intra-cavity pressure over a wide range of loading conditions and heart rates[8]. To accomplish this, the ventricle relaxes during early diastole and the walls distend readily allowing the chamber to receive a wide range of filling volumes at low filling pressures. To ensure optimal diastolic filling, the left atrium contracts before ventricular activation, providing an additional boost to ventricular filling. While two aspects of the heart's diastolic characteristics (i.e. relaxation and stiffness) are often considered together, they actually describe two different properties. Relaxation is an energy-dependent process (requiring the removal of cytoplasmic calcium by the sarcoplasmic reticulum) that begins immediately after contraction and lasts through the phase of isovolumic relaxation and the phase of early ventricular filling, during which the myocardial fibres lengthen rapidly. Stiffness, by contrast, is a feature that is measured at end-diastole, when filling is virtually complete. The diastolic chamber stiffness of the ventricle (dP/dV) is the inverse of compliance or distensibility (dV/dP). dP/dV is the slope of the tangent to the curvilinear passive pressure-volume relations of the left ventricle, increasing with increases in ventricular volume and filling pressure. To understand the rationale of non-invasive assessment of diastolic function, it is essential to appreciate something of the behaviour and filling properties of the left ventricle. Closure of the aortic valve after left ventricular ejection marks the end of systole and the onset of diastole. The period between closure of the aortic valve and the opening of the mitral valve is the isovolumic relaxation phase, which is characterized by a rapid decrease in left ventricular pressure without a change in left ventricular volume. After the isovolumic relaxation period, diastolic filling of the left ventricle normally has three distinct phases: (a) the rapid filling phase during which most of the filling occurs abruptly but passively-with the ventricle relaxing to accommodate the inflow of blood, (b) diastasis, which is characterized by a slower filling with relatively little further increase in left ventricular pressure, and (c) atrial systole, in which contraction of the left atrium delivers a small volume of blood (often with a small increase in pressure) to complete the filling of the left ventricle to its end-diastolic volume. The ventricular relaxation rate, an important determinant of early filling, is influenced by several factors. Inotropic influences not only increase the speed and force of contraction, so shortening systole, but they also increase the rate of relaxation. Negatively inotropic influences have the opposite effects [10]. Changes in chamber geometry and wall thickness affect the passive filling properties of the ventricle and should be distinguished from the intrinsic mechanical properties of cardiac muscle [10]. To date, the only definitive methods for assessing diastolic function have required direct measurement of intracardiac pressures, which can only be obtained by cardiac catheterization. Because direct measurements of diastolic function are complex and invasive, many have sought non-invasive methods that do not entail measurement of intracardiac pressure. There are two basic ways in which echocardiographic examination of the heart may be used to assess diastolic function. The first estimates of rate of change of left ventricular volume during diastole by means of two-dimensional echocardiography, and produces a succession of images of a selected ventricular cross section. The second uses the Doppler approach, which measures the velocity of transmitral inflow of blood into the left ventricle. The findings of the two approaches are not identical and each method has inherent advantages and disadvantages. Two-dimensional echocardiography Two-dimensional echocardiagraphy methods are just one example of an established general approach to assessing ventricular filling so as to make inferences about ventricular relaxation and compliance. Ventricular filling patterns were originally obtained from sequential angiographic or radionuclide estimations of volume, differentiated with respect to time to give the first derivative of left ventricular volume (dV/dt) which, during diastole, is the filling rate. The commercial availability of automatic edge detection algorithms has greatly expanded the general feasibility of using two-dimensional echocardiography for estimating diastolic filling rate from non-invasive indications of dV/dt. In particular transoesophageal echocardiography (TEE) can automatically display a surrogate of dV/dt, namely the first derivative of left ventricular short-axis area, dA/dt (Fig. 1)[11].Fig. 1: Example of diastolic function evaluated with transoesophageal two-dimensional echocardiography using an automatic border detection system. The time-trace displays the electrocardiogram and two other real-time waves, namely, the area of the left ventricle and its first derivative, dA/dt: the numerical values of end-diastolic area (EDA), end-systolic area (ESA), fractional area changes (FAC), peak filling rate (PFR), peak ejection rate (PER), and (t-PFR) which is the time from mitral valve opening (i.e. beginning of the left ventricular filling) to the PFR.Peak filling rate (PFR), as estimated by peak dA/dt in the absence of mitral valve disease, reflects a composite of the preload, left atrial pressure, ventricular wall thickness, and viscoelasticity of the myocardium. The absolute value of PFR is usually normalized for ventricular volume and expressed in units of end-diastolic volumes per second (EDAs−1). Typical normal values for PFR are 2-5 (EDAs−1). PFR is reduced by anything that slows left ventricular inflow, whether because of hypovolemia, slowed relaxation (as in myocardial ischaemia) or factors that include chamber stiffness (as in the concentric ventricular hypertrophy of hypertension, aortic stenosis or hypertrophic cardiomyopathy) [12]. The PFR usually varies inversely with the time from mitral valve opening to the time of PFR (t-PFR). An important disadvantage of two-dimensional echocardiographic assessment of PFR and t-PFR is that the frame rate is relatively slow (30 frames per s), so that rates of change of estimated areas (and therefore volumes) cannot be followed with high fidelity. Furthermore, incongruities in time relations are introduced during the conversion of digital information to analogue video data by the digital scan convertor. This phenomenon leads to a mismatching of events on the screen, which may produce misleading values. Recording techniques and parameters of doppler transmitral inflow TEE Doppler transmitral inflow velocity is recorded using the midoesophageal transverse four-chamber view or midoesophageal longitudinal two-chamber view, both of which allow the probe a 'view' through the mitral valve. The waveforms of transmitral diastolic flow velocity depend on the position of the sample volume (a region of 'focus' 3-5 mm long) of the pulsed wave Doppler within the mitral valve apparatus. Because the mitral valve is somewhat funnel shaped, the velocities increase progressively along the mitral valve apparatus from the annulus towards the outlet of the mitral orifice, as does the ratio of early rapid filling (E) to late diastolic or atrial (A) filling [9,13,14]. The recording should include several cardiac cycles and, to ensure reproducibility within patients, all measurements in a given person should be made with the sample volume in the same position within the annulus during diastole - as checked by observation in real time. There is only one exception, namely, when the purpose is to measure isovolumic relaxation time, in which case the sample volume is placed at the left ventricular outflow but close to the anterior leaflet, so as to record both inflow and outflow signals (Fig. 2).Fig. 2: Schematic representation of a recording of left ventricular outflow velocities and mitral inflow velocities as measured from a midoesophageal view with pulsed Doppler: the sample volume is placed at a position intermediate between the left ventricular outflow and the anterior mitral leaflet. (1) closure click of the mitral valve; (2) opening click of the aortic valve; (3) closure click of the aortic valve; (4) opening click of the mitral valve; The IVRT is the interval between 3 and 4; E, early diastolic filling peak velocity; A, atrial peak filling velocity; AT, acceleration time; DT, deceleration time; DR, deceleration rate, determined as the slope of the decline from the peak of the early diastolic filling velocity.The diastolic velocity trace gives rise to a large number of measurements that have been used by various investigators as putative reflections on different aspects of diastolic filling. The variables that have been found to be the most useful include (Fig. 2): the isovolumic relaxation time (IVRT); the peak early filling velocity (E) or area (time integral) of the E wave; peak late atrial filling velocity (A) or area of the A wave; the ratio of early to late peak filling velocities (E/A); the acceleration time AT, deceleration time (DT) and deceleration rate (DR). The various intervals are usually measured from paper recordings, preferably at a recording speed of at least 100 mm−1, and are corrected for heart rate by Bazett's formula: Equation 1 The normal reference values for each of these measurements are shown in Table 1.
No takes yet. Share an insight, caveat, or question.
Zimpfer et al. (1996) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: