Answers are grounded in this paper and cite their sources.
Recently, CuSbS 2 has been proposed as an alternative earth-abundant absorber material for thin film solar cells. However, no systematic study on the chemical, optical, and electrical properties of CuSbS 2 has been reported. Using density functional theory (DFT) calculations, we showed that CuSbS 2 has superior defect physics with extremely low concentration of recombination-center defects within the forbidden gap, espeically under the S rich condition. It has intrinsically p-type conductivity, which is determined by the dominant Cu vacancy ( V Cu ) defects with the a shallow ionization level and the lowest formation energy. Using a hydrazine based solution process, phase-pure, highly crystalline CuSbS 2 film with large grain size was successfully obtained. Optical absorption investigation revealed that our CuSbS 2 has a direct band gap of 1.4 eV. Ultraviolet photoelectron spectroscopy (UPS) study showed that the conduction band and valence band are located at 3.85 eV and −5.25 eV relative to the vacuum level, respectively. As the calculations predicted, a p-type conductivity is observed in the Hall effect measurements with a hole concentration of ∼10 18 cm –3 and hole mobility of 49 cm 2 /(V s). Finally, we have built a prototype FTO/CuSbS 2 /CdS/ZnO/ZnO:Al/Au solar cell and achieved 0.50% solar conversion efficiency. Our theoretical and experimental investigation confirmed that CuSbS 2 is indeed a very promising absorber material for solar cell application.
No takes yet. Share an insight, caveat, or question.
Yang et al. (2014) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: