Answers are grounded in this paper and cite their sources.
Ti-6Al-4V and Incol 718 alloys are widely used to manufacture aero-engine compressor blades, which are subjected to high-temperature and hybrid tensile-flexural loads in service. This study presents a novel measurement method to obtain composite deformation of materials under coupling of high-temperature and hybrid tensile-flexural loads, aiming to investigate the effects of tension, flexural, and temperature on the composite deformation of the above two materials. The effects of tensile load, flexural load, and temperature on the composite deformation of Ti-6Al-4V alloy and Incol 718 alloy were systematically analyzed by the established measurement method and experiments. The theoretical analysis results are in good agreement with the experimental data, the maximum relative error of the two is less than 5%. The study found that the composite deformation resistance of the material increases with the increase of tensile load, and decreases with the increase of temperature. It is worth noting that when the tensile load is properly applied, the influence of the high temperature on the composite deformation resistance of the material is significantly weakened or even disappeared. The measurement method is useful to reveal the coupling effect between tension, flexural, and high temperature on the mechanical properties of the material.
No takes yet. Share an insight, caveat, or question.
Zhao et al. (2022) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: