Answers are grounded in this paper and cite their sources.
This work demonstrates the influence of negative mode I loading in buckling-induced delamination, highlighting its significance in material science.
In modern engineering, combinations of substrate structures and thin coatings is ever present. Be it in protective applications, microelectronics, or with micro-electromechanical systems, the adhesion between the substrate material and thin film is crucial, and delamination is often the reason for the failure of the components. Therefore, the thin-film adhesion measurement is extremely important for the longevity and reliability of micro-scale components. One of the available methods is the buckling-induced delamination technique, using the compressive residual stresses in thin films to cause the films to delaminate and form a buckle. This method is well established within the material science community; however, one misconception still persists, that of discarding the negative mode I loading at the delamination crack front. The practice has led to assuming some buckling to be under pure mode II loading, but new analysis shows that the negative mode I loading pushes crack surfaces towards each other, increasing friction and apparent adhesion energy. This work presents the first description of the negative mode I influence in the case of buckling-induced delamination and the possibilities it could open for more investigation.
No takes yet. Share an insight, caveat, or question.
Žák et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: