Answers are grounded in this paper and cite their sources.
This paper investigates the performance of an ITO film of enhanced conductivity in developing thin film optically transparent frequency selective structures (FSS) for frequencies between 26 GHz and 40 GHz. Experimental results from band-stop FSS structures are obtained. Circular ring elements are considered on a triangular lattice. As part of the investigation, the performance of ITO grids is compared to that of copper and gold conductor grids which have different surface resistances. The highly conductive ITO is prepared in-house in the Optical Displays Lab. A commercially available transparent coating is employed for the gold grids. The FSS structures were etched by using standard ohotolithographic techniques and wet chemical etching. Standard glass was used as the substrate of the grids. The dielectric constant of the substrate is estimated by a free-space method. The FSS measurement set-up is comprised of an open-ended rectangular wave-guide as the transmitter with a horn antenna as the receiver. A network analyser (HP8722D) is employed to obtain the transmittance through the grids. A comparison of normal incidence transmittance results for all the grids is shown in addition to transparency results for the ITO and gold coatings. (A) For the covering abstract see ITRD E109405.
No takes yet. Share an insight, caveat, or question.
Tsakonas et al. (2001) studied this question.