Answers are grounded in this paper and cite their sources.
The physical properties, chemical properties, and morphology of particles from a current technology diesel engine run under steady-state conditions were determined during five campaigns across three calendar years. Concentrations of particulate matter, NO x, HC, CO, and CO 2 measured at a fixed sampling position were found to be repeatable between different campaigns. However, particle size distributions and number concentrations were significantly affected by dilution conditions. Particle density, estimated using a volume size distribution estimated from an ELPI together with measured mass, was found to be below 1 g/cm 3 at nonzero loads, but this is explained by an overestimation of volume by the ELPI due to particle fractal properties. Particle phase SO 4 2 -, NO 3 -, PAH, organic carbon, and elemental carbon were found to vary with engine operating modes. Particles emitted from a modern diesel engine had similar cluster structures to those from old engines but consisted of smaller basic particles when analyzed with a TEM. A semivolatile liquid fraction was not normally visible in the TEM but was seen when trapped within a folded carbon film. Very fine (<10 nm) single particles were observed in diluted exhaust by TEM and confirmed by SMPS.
No takes yet. Share an insight, caveat, or question.
Shi et al. (2000) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: