Answers are grounded in this paper and cite their sources.
Demonstrates hardware implementation impacts voltage in single-site Tesla charging setup, suggesting broader applications.
Non-OCPP electric vehicle (EV) chargers lack site-integrated monitoring and supply-control, limiting their use in real-time energy management systems. This paper presents a Smart Distribution Panel that closes this gap via panel-side observability and an operator-commanded single-phase/three-phase (1Φ/3Φ) supply reconfiguration. In a single-site feasibility study, the panel is characterised with one consumer Tesla Wall Connector Gen 3 (Non-OCPP) and one Tesla Model Y at a Taiwan 3Φ3W 220 V site, using a CPM-80 meter (IEC 62053-22 class 0.2S), interlocked contactors, an e-stop relay, and a Raspberry Pi 4 data path. Phase-mode transitions interrupt charging for ∼5 s, resolved by the IEC 61851-1 handshake. A 74.5-min stepwise session—driven by the OCPP DC fast charger with the Non-OCPP Wall Connector idle—yields a site-specific ensemble PCC-bus sensitivity V=224.85−0.147P (R2=0.991), characterising the site + DC-charger + base-load ensemble observed through the panel’s metering rather than the panel’s Non-OCPP path; an OpenDSS bounded sanity check gives an upper-bound slope of 0.26–0.28 V/kW. The one-second data stream supports a non-autoregressive (Non-AR) LSTM residual-detection layer (8-seed RMSE 0.310±0.084 V). A synthetic voltage-drop sensitivity sweep (ROC-AUC 0.81–0.97) characterises sensitivity to injected perturbations, not real-world fault detection. Feasibility is demonstrated only for the tested single-site configuration; multi-site, multi-EVSE, multi-EV generalisation, autonomous demand response, and OCPP session-level features are not demonstrated and are stated as future work.
No takes yet. Share an insight, caveat, or question.
Luo et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: