Answers are grounded in this paper and cite their sources.
An electroless bumping method was developed both for flip chip and TAB applications. Electroless Ni/Cu plating is a maskless low-cost approach to bumping directly on aluminum bondpads. An immersion tin layer for coating and soldering is plated on the copper. Due to the high alkalinity (pH>12) of electroless Cu baths, a thick Ni layer of about 7 /spl mu/m is required on the aluminum for seating. A shear strength of 180 cN and a contact resistance of less than 2 m/spl Omega/ for the bumps were obtained. Because of the high hardness of nickel, conventional gang bonding techniques are not applicable. The hardness of electroless copper is about 200 mHV/sub 25/, and after annealing in the range of 130-150 mHV/sub 25/ thermocompression gang bonding of Au plated tape to the Ni/Cu/Sn metallization was carried out. The average pull strength was 50 cN. The influences of the size and electroless solder plating of the deposited copper are also investigated.>
No takes yet. Share an insight, caveat, or question.
Aschenbrenner et al. (1995) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: