Answers are grounded in this paper and cite their sources.
The kinetic crystallization behavior of PLA (polylactic acid) and PLA/MMT nanocomposites containing 3 wt% montmorillonite (MMT) was examined in order to develop a new technique for obtaining the relative crystallization degree of a material from the spherulite occupation area based on images obtained using a charge-coupled device (CCD) camera. In addition, the relative crystallization degree is discussed in terms of the Ozawa theory. The effect of MMT filler on the mechanical properties of PLA/MMT nanocomposites, the number of spherulites generated in the nanocomposites, and the linear growth rate of these spherulites were also examined experimentally. The relative crystallization curves obtained by CCD and by DSC measurement were found to be approximately the same. Moreover, it was found that the Ozawa theory could be applied not only to PLA but also to PLA/MMT nanocomposites. In these nanocomposites, the number of spherulites decreased and the linear growth rate slightly increased ; moreover, the rate of crystallization also increased. The tensile and flexural modulus of the PLA/MMT nanocomposites containing 3 wt% MMT were 5.2-14.3% greater than those of PLA, and annealing resulted in a further increase of about 4.0-20.7%. However, the Izod impact value decreased due to the increase in rigidity caused by annealing and the addition of filler.
No takes yet. Share an insight, caveat, or question.
Mitsuta et al. (2007) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: