Answers are grounded in this paper and cite their sources.
There has been a significant debate related to whether a material with a high glass transition temperature can be obtained from a polymerization performed at a significantly lower temperature (e.g., ambient temperature). To investigate this issue and understand the factors that play a role in determining the relationship between glass transition temperature ( T g ) and cure temperature ( T cure ), three model systems with different degrees of heterogeneities were studied: triethylene glycol dimethacrylate (TEGDMA), diethylene glycol dimethacrylate (DEGDMA) (more heterogeneous), and styrene−divinylbenzene copolymer (St- co -DVB) (more homogeneous). These systems were photopolymerized in a temperature cell while simultaneously monitoring the sample temperature with the T cure varying from 25 to 95 °C. The polymerization rate and final double-bond conversion were monitored using near-infrared (NIR) spectroscopy. The T g of the exact sample cured within the NIR was subsequently measured using dynamic mechanical analysis (DMA). Since this work utilized living radical photopolymerizations, the traditional issues associated with characterizing chain polymerizations (specifically, trapped radicals that persist after cure) were eliminated. It was found that the differences between T g and T cure were significantly greater for the more heterogeneous multi(EG)DMA system than for the less heterogeneous St- co -DVB system with the T g − T cure being as large as 100 °C. Therefore, heterogeneous networks with broad distributions of relaxation times like DEGDMA exhibit unique cure behavior and facilitate obtaining a higher T g as a function of T cure than is possible in a comparable, more homogeneous network.
No takes yet. Share an insight, caveat, or question.
Lu et al. (2001) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: