Answers are grounded in this paper and cite their sources.
The limited lifespan of protective coatings attracted interest in studying the failure phenomena and investigating various coating deposition techniques. In this study, a new laser modification technique is proposed and examined on air plasma sprayed thermal barrier coatings. Thermal barrier coatings must have a minimal mechanical response to temperature variations, i.e. thermal expansion-induced stresses while having low thermal conductivity and excellent resistance to environmental agents. This paper reports a novel post-treatment approach allowing independent control of the elastic modulus in the coating and on its surface by creating a hollow internal anatomy covered by a dense protective layer. The hollow internal microstructure aims to recreate a columnar-like structure in air plasma sprayed coatings inspired by the electron-beam physical vapour deposited coatings, known for their excellent strain tolerance properties. To protect the coating from chemical and mechanical degradation and to cut the generated oxygen short path, the top surface of the coating is subsequently melted with a continuous-wave laser, creating a dense erosion and corrosion-resistant surface. The modification approach was applied to the state-of-the-art air plasma sprayed 8 wt% Yttria Stabilized Zirconia topcoats and comprehensively benchmarked against the same air plasma sprayed, non-modified, coating in terms of thermal shock, erosion resistance and response to molten silicon sand penetration, and showed significant improvements in erosion and CMAS tests, and 11 % improvement of thermal fatigue.
No takes yet. Share an insight, caveat, or question.
Ushmaev et al. (2023) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: