Answers are grounded in this paper and cite their sources.
Asphaltene precipitation and deposition in rock surfaces in oil reservoirs causes formation damage and leads to low well productivity. Therefore, analyzing the asphaltene behavior in terms of precipitation, deposition and its impact on reservoir properties is vital for predicting the production performance of asphaltic oil reservoir. Pure solid model has been widely employed to predict asphaltene precipitation. However, this approach requires a series of flash calculations through a trial-and-error procedure. This leads to higher computational time. Therefore, in this work, a modification in pure solid model is introduced so that asphaltene precipitation can be estimated explicitly in a single-stage flash calculation in each time step, resulting in reduction of computational time. At a sample pressure 2800 psia, asphaltene precipitation calculation has been presented by applying both pure and modified solid model. The comparative results show a difference of around 10% between these two methods. This work also discusses the simulation of wellbore region of production well in an asphaltic oil reservoir that experiences asphaltene precipitation and deposition. An analysis regarding development of asphaltene precipitation and its consequence on reservoir properties (porosity, permeability) and pressure is presented. For simulation, the black oil model of four phases (water-oil-gas-asphaltene) is developed and a detailed description on mathematical model development is presented. The result from the simulation shows that around the wellbore, the asphaltene precipitation is maximum resulting to maximum damage in permeability and porosity. In addition, comparing between “asphaltene precipitation” and “no asphaltene precipitation” cases, a difference of 11.2% in cumulative oil production is observed. • A new modification in solid model for explicit estimation of asphaltene precipitation. • A small difference between estimations by modified model and experimental data. • A faster modified method with less steps. • Solid molar volume of asphaltene with the most impact on asphaltene precipitation. • Total asphaltene content in asphaltene precipitation with the minimal impact.
No takes yet. Share an insight, caveat, or question.
Akter et al. (2024) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: