Answers are grounded in this paper and cite their sources.
The electrochemical discharge of lithium thin films, prepared in ultrahigh vacuum, has been explored in solutions. Prior surface characterization of the products of the reactions between clean lithium and , , , and various solvents, using x‐ray photoelectron spectroscopy, are reviewed, as they pertain to the kind of surface chemical reactions which occur to the clean lithium surface, after its formation, and prior to its immersion into the electrolyte. The interaction of the clean surface with the backfill gases, and the gases above the solution leads to a predominately sulfite surface layer, overlaying a thin oxide/sulfide product layer. The electrochemical discharge characteristics of this surface, compared with a thin film which had seen 10 2 –10 4 Langmuirs of exposure, showed that the initial oxide formed in the vacuum chamber had a significant effect on both the steady‐state potential achieved by the anode, as well as the time necessary to achieve that steady‐state potential. Interestingly, oxide formed from pure exposures had a more passivating effect on the lithium thin film, with respect to electrochemical discharge, than did comparable pre‐exposure to . The effect of these oxide layers is also compared with the effect of films formed on the lithium surface as a result of exposure to the electrolyte over a period of a few hours.
No takes yet. Share an insight, caveat, or question.
Zavadil et al. (1990) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: