Answers are grounded in this paper and cite their sources.
Hydraulic-supported single-point incremental forming (HS-SPIF) has demonstrated considerable potential for improving both formability and dimensional accuracy in incremental sheet forming. However, the combined influence of hydraulic support, rolling-direction-dependent hardening, and corner-induced strain localization on the geometric accuracy of non-axisymmetric components has not yet been systematically quantified. This study presents a coupled numerical-experimental investigation of HS-SPIF applied to AA1050 aluminum alloy using a truncated square pyramid as a representative non-axisymmetric geometry. An experimentally calibrated fracture forming limit (FFL) was integrated with rolling-direction-dependent Voce hardening laws into a finite element model, and the numerical predictions were validated through HS-SPIF experiments. The effects of hydraulic pressure, wall angle, tool feed rate, and vertical step size on both forming height and geometric accuracy were systematically evaluated. The rolling-direction-dependent constitutive model calibrated along the rolling direction provided the highest predictive accuracy, reducing the forming-height prediction error to 2.46% and the average geometric-deviation error to 2.02%, compared with 5.87% and 11.91% for the models calibrated at 45° and 90°, respectively. A hydraulic pressure of 0.1 bar increased the achievable forming height by 28.2%, whereas 0.2 bar reduced the average geometric deviation from 0.373 mm to 0.324 mm, corresponding to an improvement of approximately 13.1%. The highest geometric accuracy was further achieved using a tool feed rate of 750 mm/min and a vertical step size of 0.5 mm. The results indicate that geometric accuracy in HS-SPIF is governed by the coupled interaction between rolling-direction-dependent hardening, hydraulic support, and corner-induced strain localization, rather than by hydraulic pressure alone. These findings provide new insight into deformation mechanisms governing non-axisymmetric HS-SPIF and offer practical guidance for improving the dimensional accuracy of complex aluminum alloy components.
No takes yet. Share an insight, caveat, or question.
Nguyen et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: