Answers are grounded in this paper and cite their sources.
This study examined the use of a low-cost time-of-flight (ToF) sensor to measure forces on a robotic gripper. A novel, dual-finger, low-cost gripper with changeable fingers was designed and 3D printed. The gripper design was combined with a set of low-cost springs and the ToF sensor. Following a calibration procedure of the elastic, the gripper leverages on the linear elasticity of the springs to convert the ToF-estimated displacement into a force measurement. Calibration was performed with a six Degrees of Freedom (DoF) IIT FT17S/T miniature force sensor. An Arduino Uno embedded controller was used to design an end-user interface between the robotic gripper and the operator: a keypad allowed for setting specific gripping forces and reading the fingers’ displacement on the Arduino serial monitor. An Organic Liquid Crystal Display (OLCD) external display was also implemented to improve the end-user experience. This study showed that low-cost systems can be used to design, manufacture, and integrate robotic devices: the precision and accuracy of such a solution have been discussed, with consideration on how to improve the design through the integration of an Organic Light-Emitting Diode (OLED) 128x64 Pixel SSD1306.
No takes yet. Share an insight, caveat, or question.
Mutinda et al. (2024) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: