Answers are grounded in this paper and cite their sources.
The flash technique has been used on a systematic series of drawn low-density polyethylenes. Results from two different temperature monitoring modes are compared. Both the temperature rise of the rear face and the difference between front- and rear-face temperatures was measured on each sample using the same instrumentation. A positive difference of <10% in the thermal diffusivity by the rear-face analysis was observed over the differential method. Radiation loss corrections were applied to both analyses and estimated by a heat balance for the differential case. Instrument pressures below which losses to the air become negligible were calculated and experimentally confirmed. The thermal conductivity calculated from diffusivity for the low-density polyethylenes is shown to be proportional to the extent of deformation in the draw direction.
No takes yet. Share an insight, caveat, or question.
Jonza et al. (1984) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: