Answers are grounded in this paper and cite their sources.
The complete separation of the toxic non-ortho-substituted polychlorinated biphenyls (PCBs) PCB-77, PCB-126 and PCB-169 from the technical PCB mixtures Askarel and Aroclors (A1232, A1242, A1248, A1254, A1260 and A1262) was obtained on two series coupled narrow-bore columns: 50 m × 0.25 mm, 0.26 μm 5% diphenyldimethylsiloxane (CP-SIL-8) and 25 m × 0.2 mm, 0.1 μm 5% 1,2-dicarba-closo-dodecarborane dimethylsiloxane (HT-5). The high upper temperature limit for these GC-phases (>300°C) allowed for fast temperature programming and short analysis time (60 min). In addition to the non-ortho-substituted PCBs most of the toxic mono-ortho-substituted PCBs were completely separated from other PCBs (PCB-74, PCB-81, PCB-105, PCB-118, PCB-123, PCB-157 and PCB-189). Only four toxic PCBs were eluted with interference: PCB-60/PCB-56, PCB-114/PCB-134, PCB-167/PCB-128 and PCB-156/PCB-202. These could be analyzed satisfactorily on a CP-SIL-19 column i.e. 50 m × 0.25 mm, 0.20 μm 14% cyanopropylphenyl 1% vinyldimethylsiloxane. The 2,3,7,8-TCDD toxicity equivalents (TEQ) of the technical mixtures, analyzed by GC-ECD and GC-MS (ITS-40), were determined from published toxicity equivalent factors (TEF). Aroclor A1254 was the most toxic PCB formulation (56–216 mg TEQ kg−1 depending on the TEF model used) and A1262 the least toxic formulation (4–11 mg TEQ kg−1). PCB-74, PCB-77, PCB-105, PCB-118, PCB-126 and PCB-156 contributed with 80–99% of the total toxicity in all technical mixtures and it is suggested that future PCB legislation should be based on these six congeners.
No takes yet. Share an insight, caveat, or question.
Larsen et al. (1992) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: