Answers are grounded in this paper and cite their sources.
Explores aerodynamic optimization to reduce drag in electric vehicles, indicating potential efficiencies.
Aerodynamic drag reduction has become increasingly important for battery-electric vehicles (EVs), particularly in the low drag coefficient ( C d ) regime, where further aerodynamic improvement progressively depends on production-oriented refinement under realistic engineering constraints. This study investigates the aerodynamic development process of the production executive-class electric sedan Stelato S9 under progressively constrained styling, engineering, and manufacturing conditions, with emphasis on the evolving role of steady-state CFD simulations during different development stages. During the early-stage pre-clay development phase, extensive steady-state CFD simulations were conducted under relatively high geometric freedom to establish a low-drag vehicle architecture. Representative aerodynamic optimization measures associated with front-end pressure redistribution, wheel-region flow organization, and rear-body wake regulation collectively achieved a drag reduction of approximately 26 counts (Δ C d ≈ −0.026). As aerodynamic development progressed, subsequent refinement increasingly relied on localized production-oriented optimization measures under constrained geometric conditions. Three rounds of clay-model aerodynamic refinement and wind-tunnel validation were subsequently conducted, yielding measured drag coefficients of C d = 0.214, 0.216, and 0.211, with corresponding CFD predictions of C d = 0.213, 0.220, and 0.218, respectively. The results indicate that steady-state CFD simulations generally provided reliable aerodynamic trend prediction for optimization measures dominated by attached or geometry-constrained flow structures, whereas significantly larger discrepancies were observed for optimization measures involving strongly separated rear-body wake flows. Across the investigated clay-model configurations, the baseline drag-coefficient prediction error of the CFD simulations remained within approximately 4% compared with the wind-tunnel measurements. The final production vehicle achieved a drag coefficient of C d = 0.196 at 120 km/h through the combined effects of exterior aerodynamic refinement, underbody aerodynamic optimization, and electronic rearview mirrors. Overall, the present study provides production-oriented engineering insight into aerodynamic development characteristics and CFD applicability in the sub-0.20 C d regime under realistic engineering constraints.
No takes yet. Share an insight, caveat, or question.
A 2026 study studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: