Answers are grounded in this paper and cite their sources.
This study focused on micro fibers as a filler, and examined its effect on mechanical properties such as strength and modulus of foamed plastics. K2O·8TiO2 fiber, which is of the aciculate type, and ZnO fiber, which is of the tetrapod type, were used as fillers. Polystyrene (PS) resin composites with varied contents of above fibers were prepared. Foaming of these composites was performed, and the effect of micro fibers on foam ability as well as its contribution to bending strength and modulus was investigated. Consequently, the followings have been clarified. 1) A foamed product containing micro fibers is smaller in cell size and has higher cell density than a foam product of pure PS, irrespective of the type of fiber contained therein. Namely, micro fibers produce the effect of a nucleating agent for cells. 2) A PS foamed product containing micro fibers has a greater specific bending strength than a foamed product of pure PS. The improvement in the specific bending strength is about 60% when containing 5 wt% of aciculate type fiber, and about 35% when containing 10 wt% of tetrapod type fiber. 3) A PS foamed product containing micro fibers has a greater specific bending modulus than a foamed product of pure PS as the fiber content increases. An improvement of about 130% can be observed when containing 20 wt% of aciculate type fiber, and about 140% when containing 20 wt% of tetrapod type fiber.
No takes yet. Share an insight, caveat, or question.
Shimbo et al. (2008) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: