Answers are grounded in this paper and cite their sources.
A strategy was developed to create a modulable polymer surface architecture (topography, chemical composition) at the nanometer scale. Therefore, collagen was first adsorbed on a poly(methyl methacrylate) (PMMA) substrate and dried at high or low rate to produce continuous or discontinuous layers, respectively. Solutions of PMMA in chlorobenzene were then spin-coated on top of these collagen layers. The obtained surfaces were investigated using atomic force microscopy and X-ray photoelectron spectroscopy. Spin-coating with pure chlorobenzene on the continuous collagen layer produced pits in the PMMA substrate through the collagen layer; spin-coating with PMMA solutions of increasing concentrations progressively led to the formation of a surface covered by particles made of PMMA and collagen, resulting from a combination of dissolution of PMMA from the substrate and deposition of PMMA from the solution. Spin-coating with pure chlorobenzene on the discontinuous collagen layer led to dissolution of PMMA and to its redeposition on the collagen pattern, which served as a template. This provided a surface entirely composed of PMMA, with cavities in the range of 0.1−1 μm diameter and 50−250 nm depth. In this case, the surface relief was independent of the PMMA concentration of the spin-coated solution, the substrate PMMA dissolution and redeposition being the dominant processes.
No takes yet. Share an insight, caveat, or question.
Dupont‐Gillain et al. (2001) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: