Answers are grounded in this paper and cite their sources.
In this article, we present a technique for the deposition of inks, organic polymers, and solid particles, using a fluid ejector. The ejector design is based on a flextensional transducer that excites axisymmetric resonant modes in a clamped circular plate. It is constructed by bonding a thin piezoelectric annular disk to a thin edge clamped circular plate. Liquids or solid particles are placed behind one face of the plate which has a small orifice (50–200 μm diameter) at its center. By applying an ac signal across the piezoelectric element, continuous or drop-on-demand ejection of photoresist (Shipley Microposit S1400-21, S1400-27, S1805, and S1813), oil-based ink, water, or talcum powder [Mg3Si4O10(OH)2] has been achieved. Successful deposition of a photoresist has been accomplished without spinning, and thus without waste. A boundary integral method was used to numerically simulate drop formation from the vibrating orifice. Simulations have been used to optimize ejection performance.
No takes yet. Share an insight, caveat, or question.
Perçin et al. (2003) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: