Answers are grounded in this paper and cite their sources.
Comparison is made between the use of either a carbon powder or a polymer additive to the precursors in the synthesis of LiFePO 4 from the Fe(III) compound FePO 4 (H 2 O) 2 and Li 2 CO 3 . The evolution of the structural properties and phase purity with temperature and time have been monitored at all length scales by X-ray diffraction, Fourier transformed infrared spectroscopy, and magnetic susceptibility. The reactor temperature was decreased to 300 °C to investigate the early stages of the reaction. Formation of crystalline LiFePO 4 begins in the range 300−400 °C only if the polymer is used as the carbonaceous additive. This LiFePO 4 formation is made possible by the reduction of Fe(III) species by gases such as H 2 or gaseous hydrocarbons evolved during the calcination of the polymer. Moreover, decomposition of the polymer results in a carbonaceous deposit on the surface of the LiFePO 4 particles. An Li 3 Fe 2 (PO 4 ) 3 impurity found after sintering at 400 °C for 4 h was greatly reduced after sintering at 400 °C for 24 h, and phase-pure LiFePO 4 was attained at 700 °C. Where the solid carbon powder was used as the reducing agent, no Fe(II) species could be detected after sintering at 400 °C. Carbothermal reduction of Fe(III) is ruled out in this temperature range.
No takes yet. Share an insight, caveat, or question.
Ravet et al. (2007) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: