Answers are grounded in this paper and cite their sources.
In quantum dot sensitized solar cells (QDSSC), a cascade energy level structure controlled by assembly of cadmium-chalcogenide quantum dots can remarkably improve the sunlight harvesting and charge carrier lifetime. Despite the advantages of using co-sensitizers, energy conversion efficiencies are still low. An increased understanding of the causes of the low photoconversion efficiency (PCE) will contribute to the development of a straightforward approach to improve solar cell performance by exploiting co-sensitization. Herein we discuss how an excess of cadmium causes structural disorder and defect levels impacting the PCE of QDSSC devices. Thus, outer CdS1-xSex/inner CdS QD-co-sensitized B,N,F-co-doped-TiO2 nanotubes (BNF-TNT) were prepared. Chalcogenides were deposited by the SILAR method on BNF-TNT, varying the load of CdS as the inner sensitizer, while for CdS1-xSex, five SILAR cycles were used (5-CdS1-xSex), controlling the nominal S/Se molar ratio of the ternary alloy. Cd defects named as Cd-Cd energy levels were observed during CdS sensitization. Although incorporation of outer CdS1-xSex provides a tunable band gap to achieve good band alignment for carrier separation, Cd-Cd energy levels in the sensitizers act as recombination centers, limiting the overall electron flow at the BNF-TNT/CdS/CdS1-xSex interface. A maximum PCE of 2.58% was reached under standard AM 1.5G solar illumination at 100 mW cm-2. Additional limitations of SILAR as a deposition strategy of QDs are also found to influence the PCE of QDSSC.
No takes yet. Share an insight, caveat, or question.
Gualdrón‐Reyes et al. (2018) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: