Answers are grounded in this paper and cite their sources.
The morpho-structural and defect properties of SnO 2 nanoparticles, obtained by hydrothermal synthesis at 120 °C, 140 °C and 160 °C, using a SnCl 2 precursor, were comparatively investigated and correlated with their NO 2 sensing performance for in-field conditions. The constructive contributions of the nanoparticle size, faceting and oxygen vacancy concentrations had a positive effect on the sensor performances for the two samples synthesized at lower temperatures. These samples had almost similar, smaller size and the proportion of the more active, higher-index facets over the {110} facets was significantly larger than for the sample prepared at 160 °C. The concentration of paramagnetic defects, associated to complexes of oxygen vacancies in the (101) planes at the SnO 2 surface, increased with the synthesis temperature decrease. A sensor signal of 74 for the NO 2 detection limit of 3 ppm, at the operating temperature of 100 °C, under dynamic air flow with in-field-like relative humidity of 50 %, was obtained for the sample grown at 120 °C. The sensor signal was about four times higher compared to the 140 °C sample with similar size and morphology and about nine times higher than in the case of the 160 °C sample. In addition to its high NO 2 sensitivity, the 120 °C sample had a low sensor response for potential interfering gases as CH 4 and CO 2 and was relatively stable over a period of 20 months. Our results evidence the direct correlation between the sensing properties and the surface oxygen vacancy complexes and highlight the importance of an in-depth atomic-level investigation approach for the controlled synthesis of an application-oriented material.
No takes yet. Share an insight, caveat, or question.
Ghica et al. (2025) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: