Answers are grounded in this paper and cite their sources.
The emissions of hydrocarbons, nitric oxide, and carbon monoxide from one modern vehicle were measured using on-board instrumentation during about 350 miles of driving in Los Angeles, California. Emissions during on-road driving were compared to those obtained on dynamometers using the urban dynamometer driving schedule (UDDS). Although this study only used one driver and vehicle, tested over a relatively short distance, the analysis technique may be useful for a larger evaluation of off-cycle emissions. The test vehicle had low warmed-up running emissions over the UDDS and for most of the on-road testing where the air-to-fuel ratio was maintained at the stoichiometric point. However, occasional heavily-loaded conditions during the on-road testing led to richerthan-stoiehiometric operation. During these brief enrichment events, which lasted up to 29 seconds, CO emissions were increased by a factor of 2500 and HC by a factor of 40 over closed-loop stoichiometric operation. Nitrogen oxide emissions were similar during low-load stoichiometric operation and high-load enriched operation. The relatively constant gram-per-second emission rate of CO and HC observed during enriched operation suggests that such information can be combined with determinations of the frequency of enrichment for a large number of vehicles with similar calibrations to estimate the impact of the additional emissions from enrichment on emissions inventories.
No takes yet. Share an insight, caveat, or question.
Kelly et al. (1993) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: