Answers are grounded in this paper and cite their sources.
The characteristics of neutral-beam-heated ASDEX discharges exhibiting either low (L)- or high (H)-confinement are described. H-mode discharges, which are by now observed over a wide range of operating conditions, show a spontaneous improvement in particle and energy confinement after a short L-phase at the beginning of neutral injection. H-discharges yield high β p values comparable to the aspect ratio A (β p ⩽2.65~0.65 A). The most important parameter for transition to the H-mode seems to be a high edge electron temperature: T e values of -600 eV only a few centimeters inside the separatrix with radial gradients of ~300 eV/cm are measured. This requirement of high edge temperatures explains the lack of success in obtaining the H-regime in limiter discharges. Numerical simulation of the broad n e and T e profiles typical of H-mode plasmas indicates a reduction in electron thermal diffusivity by a factor of typically 2 over the entire plasma. H-mode energy confinement times are found to scale linearly with current, but to have little dependence on plasma density and absorbed beam power (P NI ⩽3.4MW). The confinement is degraded by a fast growing mode localized at the plasma edge that may be identified as a kink or tearing mode driven unstable by the high current densities at the edge.
No takes yet. Share an insight, caveat, or question.
Keilhacker et al. (1984) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: