Answers are grounded in this paper and cite their sources.
This study investigates the radiation-induced grafting of gallic acid (GA) onto commercial poly(lactic acid) (PLA) films (Nativia N20, 22 μm thickness) using gamma and electron-beam irradiation, with the aim of developing antioxidant-active packaging materials. PLA films were irradiated at 25 kGy and subjected to post-irradiation heating at 22, 45, and 60 °C in GA solution. Mass change analysis revealed that gamma-irradiated films gained up to 6.82% mass after heating at 60 °C, compared with ≤0.11% for non-irradiated controls, indicating radiation-enhanced GA incorporation. Electron-beam-irradiated samples exhibited net mass loss (−1.22% to −3.13%), consistent with radiation-induced chain scission at high dose rates. Thermogravimetric analysis showed that gamma-irradiated GA-treated films exhibited improved thermal stability, with the onset degradation temperature (T 5 %) increasing from 291.78 °C (pristine PLA) to 320 °C for films irradiated and heated at 60 °C, whereas non-irradiated films heated in GA solution showed reduced thermal stability (T 5 % as low as 240 °C). Antioxidant activity, assessed via DPPH radical-scavenging and Trolox-equivalent antioxidant capacity (TEAC), was highest in gamma-irradiated films heated at 60 °C, reaching 81.15% radical-scavenging activity after four weeks in ethanol, approximately five times greater than non-irradiated GA-treated films (15.35%). TEAC values in gamma-irradiated samples were approximately threefold higher than in non-irradiated controls. These results demonstrate a clear synergistic effect of gamma irradiation and thermal treatment on GA incorporation and antioxidant performance, establishing a scalable, initiator-free approach for producing bioactive PLA films for sustainable active packaging.
No takes yet. Share an insight, caveat, or question.
Worldlight et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: