Answers are grounded in this paper and cite their sources.
A two-Bragg-grating sensing system, demodulated with the use of a tunable Fabry-Pérot filter to detect the associated wavelength variation has been developed. To show the practicality of the system, a low cost ELED (with an output of at ) was used as the light source, incorporating readily available Bragg gratings centred around this wavelength. The relevant parameters considered in designing such a system have been analysed and are discussed in detail. With the use of a digital Gaussian filter to limit the noise, under the same conditions, the repeatability obtained was close to the optimum level achievable (with the 12-bit A/D card used), and the repeatability of the Bragg wavelength, determined with individual data points being averaged over ten measurements was 7 pm, when the signal to noise ratio was as low as 30:1. Temperature and strain sensitivities of and have been demonstrated with such an instrument. The potential for achieving a higher repeatability of the measurement is discussed.
No takes yet. Share an insight, caveat, or question.
Ning et al. (1998) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: