Answers are grounded in this paper and cite their sources.
The interaction between the solenoidal electric field and a circular cylindrical plasma column is used as the basis for the design of a pulse-operated bridge suitable for transient measurements of the electrical conductivity in the high-electron density plasma. The solenoidal electric field is generated in a single layer solenoid with a special shield preventing the axial electric field from interacting with the plasma, thereby avoiding the electric polarization and associated effects. The time varying magnetic field generated by the solenoid and the induced electric field are then the only fields interacting with the plasma, and these fields penetrate essentially unperturbed into the plasma as long as the skin depth of the plasma is large in comparison with its radius. The upper limit for the measurable conductivity is determined by the skin depth of the plasma, while the lower limit is determined by the noise level in and the maximum allowed signal on the bridge. The maximum allowed signal on the bridge is either determined by the fact that the solenoidal electric field must be sufficiently small so it does not disturb the thermal state of the plasma to a measurable degree, or else that the amplitude of the electron cyclotron frequency corresponding to the amplitude of the time varying, but essentially uniform, magnetic field must be negligible in comparison with the electron collision frequency vm so that nonlinear magnetic field effects are avoided. This makes the bridge most useful in the high pressure range (vm>ω) where the ratio between the upper and lower limits for the measurable conductivity in a typical afterglow plasma can be approximated as 1013p/ω, while the upper limit as determined by the skin depth is 1010/ω ohm−1 cm−1 for a plasma with 1 cm radius. A Gaussianlike pulse with a width of approximately 1 μsec is applied to the solenoids which are close to critically damped in the corresponding frequency range, resulting in a time resolution of less than ⅓ of a μsec for the conductivity measurement.
No takes yet. Share an insight, caveat, or question.
K. B. Persson (1961) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: