Answers are grounded in this paper and cite their sources.
Foils, made out of 99.999% pure Al (4 mil) and 99.999% pure Au (2 mil), were bombarded with 21-MeV deuterons at a temperature not exceeding 8.5^∘{}K. With a total flux of 2.5×{}10¹⁶ d/cm², the damage introduced was 0.33×{}10^-7 ohm-cm and 0.45×{}10^-7 ohm-cm, respectively, about five times smaller than the theoretical value. For Au the 1/E law for the damage production holds. No radiation annealing was observed for either metal. Isothermal annealing was performed in steps of 1^∘{}K for one hour at each temperature. Up to 50^∘{}K 65% of the damage anneals out in Al, 17% in Au. The isochronal plot of the resistance decrease for Al shows a small peak (5%) centered at 17^∘{}K, a large one at 34^∘{}K, and two at 39 and 46^∘{}K. The annealing in Au, appreciable already at the lowest annealing temperature, 9.7^∘{}K, was rather constant over the whole temperature range examined except for a large peak at 33^∘{}K and a smaller one at 45^∘{}K. Changes in the temperature-dependent part of the resistivity can for both metals be explained as a deviation from Mathiessen's rule as resistance measurements at 6^∘{}K indicate. This is in agreement with measurements on Al and Au alloys. The activation energy spectrum for Al, obtained with a frequency factor of lnB=29, shows also 4 peaks, at 0.056 eV, 0.110 eV, 0.130 eV, and 0.146 eV. The spectrum for Au is rather complex, due to the large range of the interaction of defects and the anisotropy of this metal. A recalculation of data for the annealing of deuteron-irradiated Cu and Ag shows a fine structure in peak ID. A way to choose the proper temperature increase for isothermal annealing measurements is given.
No takes yet. Share an insight, caveat, or question.
K. Herschbach (1963) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: