Determination of the Curvatures and Bending Strains in Open Trileaflet Heart Valves

The leaflets of trileaflet artificial heart valves manufactured from polyurethane, gluteraldehyde-treated porcine aortic valves and pericardial tissue are subject to cyclic stresses and strains which can reduce the lifetime of the implanted valves through leaflet calcification and fatigue failure. A detailed knowledge of the stress state within a valve leaflet throughout a cardiac cycle is desirable in order to improve the geometry of the valve leaflets and ultimately improve the valve performance. An experimental method to evaluate the radius of curvature at the free edge of the open valve leaflet is presented. The technique has been applied to polyurethane trileaflet heart valves manufactured within the authors' laboratory and to commercially available bioprosthetic valves in the fully open position under steady and pulsatile flow conditions. Simple bending theory has been applied to the polyurethane valves to calculate bending stresses and strains at the free leaflet edge based on the measured curvature. The results showed that in the fully open position the highest curvatures occurred at the commissural regions for all the valves analysed. Additional areas of high curvature were present along the free leaflet edge. Average curvatures as high as 0.85 mm-1 were observed at the leaflet commissures for the polyurethane valves with a resultant bending stress of 0.72 MPa. The porcine bioprosthetic valves showed average curvatures as high as 2.5 mm-1 which also occurred at the leaflet commissures. The results of the study have been compared to values of stress obtained from numerical analysis of closed polyurethane valve leaflets reported in the literature.(ABSTRACT TRUNCATED AT 250 WORDS)