Answers are grounded in this paper and cite their sources.
To develop ammonia-fueled micro gas turbines, an industrial-grade full-size annular combustion chamber and a gas injector specifically designed for NH 3 combustion were manufactured using 3D printing. Precracking NH 3 is proposed as an ideal solution to overcome the fuel’s low flammability. This study experimentally and numerically investigated the combustion characteristics of precracked NH 3 in the annular combustion chamber. The combustion zone maintained an equivalence ratio of 0.54 with a 0.5 MPa pressure. Experimental results revealed that even at 838 K air temperature, 20 wt % precracked NH 3 failed to sustain stable combustion. However, stable combustion was achieved when precracked degree reached 30 wt % with 560 K air and 40 wt % with ambient-temperature air. To match CH 4 ’s ignition delay time and laminar burning velocity, the required NH 3 precracked degrees were approximately 7 and 35%, respectively. The tests achieved 94.5% combustion efficiency with minimal NOx emissions of 376 ppm, though emissions increased sharply with rising initial air temperatures. Numerical analysis indicates that NO generation strongly correlates with N and HNO radicals, while initial air temperature exerts greater influence than the degree of NH 3 precracked on NO formation. The equivalence ratio in the pilot zone exerts a profound influence on the NO emission concentrations. These findings provide valuable guidance for the stable operation of NH 3 -fueled gas turbines, thereby facilitating relevant research.
No takes yet. Share an insight, caveat, or question.
Yuan et al. (2025) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: