Answers are grounded in this paper and cite their sources.
The total secondary electron yield (SEY) of dielectric materials under pulse electron beam was investigated using the collector method. Accurate SEY characterization is essential for assessing surface charging effects in the space environment. However, SEY measurements of dielectrics, particularly easily charged Al 2 O 3 , are highly sensitive to both the performance of the measurement facilities and the surface conditions of materials. Two analytical models, dc output method and pulsed output method, were analyzed and compared. The results indicate that the single-pulsed method is more suitable for air-exposed metals and poorly conductive dielectrics, whereas for clean and contamination-free metals, the dc and pulsed yield models provide consistent SEY values. To obtain intrinsic, charging-free SEY data, measurements must be performed under low electron dose conditions with appropriate charge neutralization. Otherwise, the measured SEY exhibits an exponential decay under continuous electron pulses. In addition, excessive neutralization can also reduce the measured SEY below its intrinsic level. Based on the measurement methods, SEY values for several space dielectric materials were obtained. The results demonstrate that SEY is influenced by surface morphology, increasing with surface finishing from rough to ground or polished states. However, mechanical polishing shows little effect on SEY for smooth Al 2 O 3 surfaces with roughness below 0.30 μm. Among the investigated materials, polished Al 2 O 3 exhibits the highest SEY, with a maximum value of 7.72 ± 0.18 at an incident electron energy of 900 eV.
No takes yet. Share an insight, caveat, or question.
Wan et al. (2025) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: