Answers are grounded in this paper and cite their sources.
Poly(methyl methacrylate) (PMMA) brushes with the same chain length but different graft densities were prepared on a silicon substrate by the surface-initiated atom transfer radical polymerization technique. The graft density σ was changed in a wide range extending to an exceptionally high value (0.07 < σ (chains/nm 2 ) < 0.7) by photodecomposing the surface-fixed initiator, 2-(4-cholorosulfonylphenyl)ethyltrichlorosilane (CTCS). The surface density σ i of CTCS was determined by the grazing-angle reflection−absorption FT-IR measurement. The comparison of σ and σ i suggests that there is a limiting value in σ that cannot be exceeded even if σ i is increased. The direct force measurements were made at the brush surface swollen in toluene by an atomic force microscope with a silica particle-attached cantilever. The analysis of the obtained force−distance profiles revealed that the equilibrium thickness L e scaled by the full chain length L c varies such as L e / L c ∝ σ n with n increasing from about 0.3 to 0.5 with increasing σ and that the brush with a higher σ is more resistant to compression. These results are poorly explained by the scaling theory, which was derived for “moderately dense” brushes. This suggests that the studied σ range is in the “high-density” regime, in which higher-order interactions among graft chains are important.
No takes yet. Share an insight, caveat, or question.
Yamamoto et al. (2000) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: