Answers are grounded in this paper and cite their sources.
Considering self-saturation effect and thermal effect, a detailed theoretical analysis of the output characteristics of the 2.94 μ m continuous-wave (CW) Er:YAG laser with a 10 mm long 50 at.% Er:YAG crystal end-pumped by a 976 nm LD is carried out by solving transient rate equations and heat conduction equations. It is shown that there is a minimum pump power threshold of 0.27 W for the 2.94 μ m CW Er:YAG laser. The main factor which limits the significant increase of pump power is the thermal damage risk of the crystal’s pump end-face coating. To minimize the risk, the CW operating temperature of the pump end-face coating is set to be no higher than 200 °C, and therefore the value of the pump beam waist radius is limited to 40 μ m ⩽ w 0 ⩽ 490 μ m. Within the range, a maximum 2.94 μ m CW laser output power of 4.03 W is achieved with a pump beam waist radius of 100 μ m. By bonding a 2.5 mm long YAG crystal at the pump-end of the Er:YAG crystal, the CW operating temperature of the pump end-face coating is reduced to the room temperature of 20 °C. Under this condition, the limiting factor for a substantial increase of pump power is the thermal damage risk induced by large interior thermal stress of the Er:YAG crystal. Assuming the interior thermal stress of the CW operating Er:YAG crystal is less than 341 MPa according to the material characteristics, the pump power can be increased by increasing the pump beam waist radius. When the beam waist radius is 430 μ m, a maximum 2.94 μ m CW laser output power of 38.7 W is obtained. Compared with the unbonded condition, the output power level of the 2.94 μ m CW Er:YAG laser is promoted.
No takes yet. Share an insight, caveat, or question.
Zhao et al. (2025) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: