This is the authors' abstract. We don't add key points for this paper.
In previous work at the U.S. Air Force Academy, the phenomenology and behavior of the aerodynamic plasma actuator, a dielectric barrier discharge plasma, was investigated. To provide insight into the phenomenology associated with the transfer of momentum to air by a plasma actuator, the velocity distributions upstream and downstream of a plasma actuator with an induced boundary layer were measured using freestream velocities of approximately 4.6 and 6.8 m/s for a range of frequencies (5-20 kHz) and voltages (5-10-kV amplitude). The body forces on the air were calculated using a control volume momentum balance. In a second experiment, time-averaged results were also obtained by measuring the reaction force using a pendulum. A third experiment uses an accelerometer to gain insight into the time-dependent forces or, more specifically, the direction of the forces. The results show that the body force acts within the first 4 mm above the surface of the actuator (within the boundary layer). For a constant peak-to-peak voltage, the body force is proportional to frequency, producing a constant impulse per cycle, and the energy dissipation per cycle and efficiency are independent of frequency. The time-dependent measurements support the theory that the body force of the actuator consists of one large push followed by one small pull during each cycle.
Answers are grounded in this paper and cite their sources.
No takes yet. Share an insight, caveat, or question.
Porter et al. (2007) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: