Answers are grounded in this paper and cite their sources.
The objective of this work was to investigate the combined influence of thermal ageing and phase balance on the corrosion, wear and tribocorrosion behaviour of nitrogen-sintered powder metallurgy duplex stainless steels (PM DSS). Ferrite-rich, balanced and austenite-rich compositions were produced by nitrogen-assisted sintering, followed by solution annealing and ageing at 375, 675 and 875 °C for different exposure times. Corrosion, dry sliding wear and tribocorrosion tests were complemented by microstructural characterization to identify the degradation mechanisms. Solution annealing produced the most stable microstructure, resulting in improved corrosion resistance, lower friction coefficients and enhanced wear and tribocorrosion performance. Ageing at 375 °C caused only minor changes, whereas ageing at ≥675 °C promoted extensive precipitation of Cr-rich carbides and carbonitrides, leading to chromium depletion, passive film destabilization and a marked deterioration in corrosion and wear resistance. SEM observations of the tribocorrosion tracks revealed a transition from abrasion associated with repeated depassivation–repassivation cycles in the solution-annealed condition to corrosion-assisted delamination and sustained anodic dissolution after severe ageing. The results demonstrate that thermal ageing fundamentally modifies the tribocorrosion mechanisms of nitrogen-sintered PM DSS. Residual porosity, heterogeneous nitrogen distribution and accelerated precipitation kinetics enhance the synergistic interaction between wear and corrosion, indicating that degradation mechanisms established for wrought duplex stainless steels cannot be directly extrapolated to powder metallurgy materials.
No takes yet. Share an insight, caveat, or question.
García-Hernández et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: