Answers are grounded in this paper and cite their sources.
A fully flexible strain sensor consisting of vertically aligned ZnO nanowires on graphene transferred on polyethylene terephthalate with prefabricated Au/Ti electrodes (ZnO-VANWs/Gr)/PET) has been obtained. The ZnO-VANWs were grown in solution using a seedless hydrothermal process and are single-crystalline of (0001) orientation that provides optimal piezoelectric gating on graphene when deformed mechanically. The change of the graphene channel conductance under such a piezoelectric gating through transduction of the mechanical deformation on the ZnO-VANWs/Gr was used to detect the strain induced by the deformation. Under applied normal forces of 0.30, 0.50, and 0.70 N in a dynamic manner, the ZnO-VANWs/Gr/PET strain sensors exhibited a high response and response times of ∼0.20 s to both force on and off were achieved. Under mechanical bending curvatures of 0.18, 0.23, 0.37, and 0.45 cm–1, high sensitivity of the gauge factors up to ∼248 and response times of 0.20 s/0.20 s (rise/fall) were achieved on the ZnO-VANWs/Gr/PET strain sensors. Moreover, the response changes polarity when the directions of bending alters between up and down, corresponding to the polarity change of the space charge on the ZnO-VANWs/Gr interface as a consequence of the compressive and tensile strains along the ZnO-VANWs. This result shows that the low-cost and scalable ZnO-VANWs/Gr/PET strain sensors are promising for applications in stress/strain monitoring, wearable electronics, and touch screens.
No takes yet. Share an insight, caveat, or question.
Panth et al. (2020) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: