Answers are grounded in this paper and cite their sources.
Integration of optical interconnections on a printed circuit board (PCB) is very challenging, since compatibility should be maintained with standard PCB manufacturing technology. This paper describes the use of laser ablation, a technique already used in PCB manufacturing for drilling microvias, as a suitable technique for the fabrication of multimode polymer waveguides, micromirrors, alignment features, and microlenses. A frequency-tripled Nd-YAG laser and a KrF excimer laser are used, both mounted on the same stage, resulting in very high alignment accuracies. This paper demonstrates a parallel optical link over approximately 5-cm-long PCB integrated waveguides, fully connected using a standard MT-based connector. This proves that laser ablation can be a key technology in optical board manufacturing to reach the stringent coupling tolerances.
No takes yet. Share an insight, caveat, or question.
VanSteenberge et al. (2004) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: