Answers are grounded in this paper and cite their sources.
Two types of observable consequences of the frequency dependence of Q (the absorption band concept) are discussed: (1) The observed waveform of a long-period body wave is systematically late compared to the synthetic purely elastic response. This observation can be made after the usual travel-time anomaly has been corrected for. (2) The short-period waveform of PKIKP sampling the inner core is systematically different from that of PKPBC bottoming above the inner core. This observation can be made at distances (147°–151°) where both phases are distinct, simple and similar apart from absorption effects. The long-period phase delay is measured on SRO/ASRO records of mantle P-waves from deep events, where the observed short-period onset is used to adjust the start time for the synthetic. The delay is caused by both absorption and source effects, and the two contributions are estimated in the context of a particular type of absorption and source model. If the Q model in PREM is representative of the long-period absorption, then the solution for the high-frequency cut-off of the absorption band (2πτ1)-1 is near 0.2 Hz, but values up to 1 Hz cannot be absolutely ruled out by the data. Although this result represents the integrated effect of Qα in the mantle, for teleseismic P from deep events it should be more representative of Qα in the lower mantle. The characteristic change of waveform of short-period PKIKP with respect to PKPBC is observed on NORSAR array beams, and it can be explained by absorption on the low-frequency flank of an absorption band (or peak) in the inner core. This has the following implications: the low-frequency cut-off (2πτ2)-1 of this band is above 2Hz. The minimum Qα in the centre of the band is likely to be below 100 in the upper 200km of the inner core. At body wave frequencies between 0.5 and 2.0 Hz, Qα varies here between about 600 and 200. With respect to this absorption band, inner core velocities inferred from observed short-period arrival times correspond to the relaxed elastic moduli, the unrelaxed moduli being inaccessible to observation. The intrinsic dissipation can be in shear and/or in bulk. The essential observational difference between relaxation models of shear dissipation and some diffusion models of bulk dissipation occurs on the high-frequency side of the absorption band. Hence, it is not possible to discriminate between the two mechanisms.
No takes yet. Share an insight, caveat, or question.
D. J. Doornbos (1983) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: