Answers are grounded in this paper and cite their sources.
A new, simple and high-accuracy impedance-to-digital converter (IDC) is proposed in this paper. Conventionally, the parameters of sensors that can be modeled using a parallel combination of a capacitor (C) and a resistor (R) are measured using ac bridges, excited from a sinusoidal source. Recently, with the widespread use of digital systems in instrumentation, capacitance-to-digital converters and resistance-to-digital converters gained a lot of importance. An IDC that accepts sensors having C and R in parallel and provides digital outputs directly proportional to the C and R values is presented in this paper. This can be used not only for sensors whose C and R values vary with the measurand but also when C or R of a sensor needs to be measured keeping the output not affected by parasitic R or C present in parallel with the sensing element. Another application of the IDC is in the measurement of the dissipation factor of dielectric materials. The proposed IDC is based on a dual-slope technique, and hence provides high accuracy and immunity to noise and interference. A prototype of the proposed IDC has been developed and tested in the laboratory. Accuracy of the prototype IDC developed was 0.15% for the measurement of C and 0.04% for the measurement of R. The total conversion time of the prototype converter developed is 3 s, and its total power dissipation is 175.8 mW. The IDC was also interfaced with a polymer-based impedance humidity sensor, measured its C and R values for a range of humidity, computed the humidity, and compared its performance with another instrument, showing the practicality of the proposed IDC.
No takes yet. Share an insight, caveat, or question.
Vooka et al. (2014) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: