Answers are grounded in this paper and cite their sources.
Validation and verificationFor validating the results of Flow-3D modeling, an experimental test has been performed on the model Persia-110 in the towing tank of Admiral Makarov University, which has 33(m) length, 2.5(m) width and 1.3(m) draft (Figure 2).(A) Test in the surface draft of 7 cm and speed of 1 m/s(B) CFD modeling in the same conditions of experiment Figure 2 Comparison of the results of the experiment and CFD method CFD analysisThe general configurations and dimensions of domain are shown in Figure 3.The length and width are 12 and 2.6 meters.Depth is 4 meters (3.5 for draft and 0.5 for freeboard).There boundary conditions are: Input: wave, Output: Specified pressure and other sides are symmetry.The model is situated in different depths of "h" according to (Figure 3A).There are two mesh block: one block for the total domain with coarse meshes and other block for fine meshes around the object body.The accuracy of the shape of body depends on the fine meshes (Figure 3B) (Figure 3C).For producing the wave, the input boundary condition is "Wave".Flow-3D can produce regular and irregular waves.The produced wave and the situation of object under the waves are shown in (Figure 3D).The reason of selecting each parameter is mentioned below.A. Dimensions of Domain (in meter) B. Boundary conditions in domain
No takes yet. Share an insight, caveat, or question.
Mohammad Moonesun (2018) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: