Answers are grounded in this paper and cite their sources.
p-n junction photocatalyst Cu2O/TiO2 was prepared by ball milling through doping Cu2O into TiO2 and using H2O solution as disperser. The p-n junction photocatalyst Cu2O/TiO2 was characterized by UV-Vis diffuse reflection spectrum, Scanning electron microscopy (SEM), X-ray powder diffraction (XRD) and X-ray photoelectron spectroscopy (XPS). The photocatalytic activity of the photocatalyst was evaluated by photocatalytic reduction of Cr2O7(2-) and photocatalytic oxidation of methyl orange (MO), respectively. The results showed that, for the photocatalytic reduction of Cr2O7(2-), the optimum percentage of doped-Cu2O is 1.0% (weight percentage). The photoreduction activity of the p-n junction Cu2O/TiO2 is much higher than that of TiO2 on the photocatalytic reduction of Cr2O7(2-). However, the photooxidation activity of the p-n junction photocatalyst Cu2O/TiO2 is much lower than that of TiO2 on the photocatalytic oxidation of methyl orange (MO). Namely, the p-n junction photocatalyst Cu2O/TiO2 has higher photocatalytic reduction activity, but lower photocatalytic oxidation activity. Cu2O and TiO2 were coupled highly, forming the p-n junction Cu2O/TiO2 photocatalyst. The photocatalytic activity of the p-n junction Cu2O/TiO2 was discussed by the p-n junction principle. Effect of ball milling time on the photocatalytic activity of p-n junction photocatalyst Cu2O/TiO2 was also investigated.
No takes yet. Share an insight, caveat, or question.
Liu et al. (2009) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: