Answers are grounded in this paper and cite their sources.
Experimental study shows reduced tensile strength and stiffness in fungal-colonized 3D-printed PLA/wood biocomposites, indicating trade-offs for biological surface modifications.
This study investigates the mechanical behaviour of additively manufactured biocomposites based on PolyLactic Acid (PLA) reinforced with nominal wood-particle contents ranging from 10 to 50wt. % and subsequently subjected to controlled growth of the fungus Fomes fomentarius . The aim was to analyse how post-printing fungal colonisation and the associated processing conditions influence the mechanical characteristics of the resulting wood-containing PLA specimens, particularly Young’s modulus ( E ), mean Ultimate Tensile Strength (UTS), and overall deformation behaviour. Standardised tensile tests were performed, and the corresponding stress–strain curves were evaluated. The investigated PLA/wood material combinations exhibited noticeable differences in tensile behaviour, with mean Young’s modulus ( E ) values ranging from 2231 to 2685 N/mm² and mean UTS values ranging from 31 to 38 N/mm² . Specimens subjected to fungal colonisation and the associated incubation, drying, and handling procedure consistently exhibited lower mean E and mean UTS values than the corresponding untreated specimens . Mean Young’s modulus decreased by approximately 7–11 %, while UTS decreased by approximately 2–7 %, depending on the material combination. Microscopic observations confirmed successful surface colonisation by Fomes fomentarius , whereas fungal growth within the internal specimen structure could not be detected. In addition, a supplementary screening-level Life Cycle Assessment (LCA) was conducted to compare the environmental impacts associated with the investigated PLA/wood material combinations during the Material Extrusion Additive Manufacturing (MEX AM) fabrication stage. The results indicate that electricity consumption dominated the Global Warming Potential (GWP), whereas material composition had a stronger influence on Acidification Potential (AP) and Eutrophication Potential (EP). The combined mechanical and screening-level environmental assessment provides indicative insights into the trade-offs associated with bio-based PLA/wood material combinations and their post-printing biological modification, supporting future work on more sustainable additively manufactured material systems.
No takes yet. Share an insight, caveat, or question.
Panjalipoursangari et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: