Answers are grounded in this paper and cite their sources.
Process gases were sampled from the outlet of a tungsten chemical vapor deposition (CVD) reactor into an Inficon Composer™ acoustic sensor for in situ chemical gas sensing and real-time film thickness metrology. Processes were carried out on an Ulvac W CVD cluster tool at 10 Torr from 340 to 400 °C using a H2/WF6 gas mixture. Sampled gases were compressed through a diaphragm pump up to 100 Torr as required for accurate measurements in the acoustic cell. The high depletion of the heavy WF6 precursor (up to 30%) generated a significant variation of the average gas molecular weight and consequently of the mass-dependent resonant frequency measured by the acoustic sensor. The monitored signal was integrated over the process time, and the integrated area was correlated to the deposited W film thickness determined by ex situ measurements. The average error on this in-tool and real-time metrology was less than 1% over 30 wafers processed, either under fixed process conditions or while varying key process variables such as deposition time or temperature. A dynamic physically based simulator was also developed to validate the system response under different process conditions and demonstrate the fundamental understanding of this method. The metrology achieved represents a significant improvement over previously published data [L. Henn-Lecordier et al., J. Vac. Sci. Technol. A 19, 621 (2001)] obtained on the same system but in the sub-Torr process pressure regime, where low depletion rates (around 3%) had limited the metrology to 7% error. With an error less than 1%, this in situ chemical sensing approach could be efficiently exploited for real-time course correction, e.g., using end-point film thickness control.
No takes yet. Share an insight, caveat, or question.
Henn‐Lecordier et al. (2003) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: