Answers are grounded in this paper and cite their sources.
We report the stress as a function of temperature of films of undoped and doped silicon oxide. These materials were prepared by chemical vapor deposition (CVD) from a variety of chemical reactions, under different physical conditions, and include DADBS (450°, 500°, and 550°C), TEOS (500° and 685°C), silane + oxygen (400°, 410°, and 440°C), wet oxygen (950°C), and plasma‐enhanced (PECVD) silane + nitrous oxide (250°C). Data from each oxide were subjected to a linear least squares analysis and the first‐order equation thus obtained was used to calculate the stress at 28°C and at the deposition temperature, the so‐called intrinsic stress. From the slope of the line, we found the thermal coefficient of expansion of the oxides almost always to be less than that of <100> silicon. Dopants such as phosphorus and especially the combination boron and phosphorus lower the intrinsic stress of an oxide film relative to the undoped material and cause the rate of change of stress with temperature to be relatively flat. Except for 8% P‐ and 2,5% B,P‐glass, oxides deposited below 500°C show a thermal hysteretic effect on heating to 450°C in air. Invariably the films become more tensile stressed, which must result from a shrinking and/or an extrusion of atoms from the matrix of the oxide. In contrast, thermally grown oxide exhibits a decided compressive stress that shows no hysteresis. No doubt this results from oxygen atoms intruding into the surface of the silicon lattice as the oxide layer grows.
No takes yet. Share an insight, caveat, or question.
Smolinsky et al. (1985) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: