This is the authors' abstract. We don't add key points for this paper.
The interactions between oppositely charged surfactant/polymer mixtures have been studied using neutron reflectometry with supplementary surface tension measurements. The cationic surfactant dodecyl trimethylammonium bromide (C 12 TAB)/anionic polyelectrolyte sodium poly(styrene sulfonate) (NaPSS) system is compared with a system containing anionic sodium dodecyl sulfate (SDS) and cationic poly(vinyl pyridinium chloride) (PVPmCl). The PVPmCl/SDS mixture has been studied both with and without added electrolyte. Neutron reflection shows that for both systems, the surface consists of a mixture of polyelectrolyte and surfactant over a range of surfactant concentrations from above the critical micelle concentration (CMC) to CMC/100 for polymer concentrations between 10 and 140 ppm. In the lower surfactant concentration range, the amount of surfactant adsorbed approximately corresponds to a surfactant monolayer (area per molecule ∼ 35−45 Å 2 for SDS in the presence of 0.1 M NaCl, 35−60 Å 2 without NaCl, and 50−60 Å 2 for C 12 TAB with 0.1 M NaBr). However, at higher concentrations and in the presence of electrolyte, this increases to an amount approximately corresponding to three adsorbed layers (area per molecule = 12 Å 2 for SDS and 17−20 Å 2 for C 12 TAB). This increase is not observed for PVPmCl/SDS in the absence of 0.1 M NaCl. The structure of the higher concentration layer is a sandwich structure with an outer surfactant layer and a submerged polymer/micellar (spheres or rods) or polymer/defective bilayer. The surface tension and neutron results can be interpreted qualitatively in terms of three species in the system, a surface active complex PS S, a bilayer complex, which can only adsorb on a preformed PS S layer, and a bulk solution complex PS M . PS S is adsorbed at very low concentrations of surfactant, possibly even before any PS M is formed in the bulk solution. At high concentrations, there are two effects. There may be adsorption of complexes to the layer of PS S already at the surface. However, the formation of is in competition with the formation of PS M . If the latter is dominant, there is no secondary adsorption of, as is the case for PVPmCl/SDS in the absence of electrolyte, and the surface tension may increase very sharply with surfactant concentation at the point where the formation of PS M in the bulk solution is complete. If there is secondary adsorption of PS M or PS S, as for NaPSS/C 12 TAB with or without electrolyte and PVPmCl/SDS with electrolyte, the surface tension should show a more modest increase at this concentration.
Answers are grounded in this paper and cite their sources.
No takes yet. Share an insight, caveat, or question.
Taylor et al. (2002) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: