Answers are grounded in this paper and cite their sources.
Experimental analysis reveals that extrusion-induced phase redistribution improves anodic efficiency and suppresses self-corrosion in Mg–Al–Mn anodes, highlighting a pathway for durable...
The long-term performance of Mg–air anodes in chloride electrolytes is governed by the interplay of phase architecture, self-corrosion, discharge-product evolution, and anodic utilization. This study elucidates the processing-dependent influence of Al in Mg–0.25Mn–xAl anodes by comparing low- and high-Al alloys in the as-cast (AM20, AM90) and extruded (EXAM20, EXAM90) conditions in 3.5 wt. % NaCl. Microstructure, immersion corrosion, time-dependent PDP/EIS analysis, 24 h galvanostatic discharge at 10 mA cm- 2 anodic efficiency, and post-discharge macroscopic/SEM morphology were correlated. In the as-cast state, increasing Al content refined the α-Mg grains but generated a continuous Al-rich/β Mg₁₇ Al₁₂ -phase network in AM90, promoting discharge activation while intensifying micro-galvanic self-corrosion and hydrogen evolution. Homogenization followed by extrusion disrupted this network and redistributed Al-rich and Al–Mn-rich particles within fine recrystallized α-Mg grains. Consequently, EXAM90 exhibited the lowest immersion corrosion rate and hydrogen evolution while maintaining the most negative average discharge potential (− 1.484 V vs. SCE). EXAM90 also delivered the highest anodic efficiency (51.0 ± 1.2%), indicating the most effective utilization of Mg during discharge. Post-discharge observations revealed persistent Mg ( OH )₂ -rich deposits on the low-Al alloys, whereas EXAM90 exhibited discontinuous product coverage, open surface channels, and controlled removal of discharge products. These findings demonstrate that extrusion-induced phase redistribution partially decouples anodic activation from self-corrosion, enabling improved discharge performance and Mg utilization. This positions EXAM90 as a promising anode for long-life primary Mg–air batteries, especially in marine and backup power systems where sustained performance and material utilization are critical.
No takes yet. Share an insight, caveat, or question.
najafi et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: