Answers are grounded in this paper and cite their sources.
The flow-reversal end chambers are used quite often in commercial automotive mufflers. The conventional axial plane-wave theory is not able to predict their acoustic performance because of the fact that the length of the end chambers is not enough for the evanescent three-dimensional modes generated at the junctions to decay sufficiently for frequencies below the cut-off frequency. Also, due to the large expansion ratio at the inlet, the first few higherorder modes get cut on even in the low-frequency regime. This necessitates a finite element or boundary element analysis, which is cumbersome and time-consuming. Therefore, an ingenious one-dimensional method has been developed. It models plane-wave propagation in the transverse direction between the incoming pipe and the return pipe, with the lateral-end cavities being modeled as variable-area quarter-wave resonators. Making use of this novel approach, the transfer matrices have been derived for elliptical and circular cross-section mufflers, which enable these elements to be analyzed along with the rest of the muffler elements by means of the transfer matrixbased muffler program. Through a comparison with a full, three-dimensional analysis on commercial software, it is shown that the one-dimensional approach presented in this paper is able to predict the transmission loss quite accurately up to about 1000 Hz for typical automotive mufflers.
No takes yet. Share an insight, caveat, or question.
Mimani et al. (2010) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: